"Stick-on" Vents

INSTRUCTION FOR STICK-ON VENT

INSTALLATION INSTRUCTIONS

 

(Diagram)

1. Select an area on covering for ventilator installation.

(Note: for best result locate vent at the highest angular section of covering...

AVOID SEAMS, FOLDS, or DEEP PERMANENT CREASES).

*** SPECIAL NOTE *** Selected surface are should be CLEAN, DRY, and FREE OF GREASE OR OIL. Ambient/air tempature should be above 50 degrees Fahrenheit (10 degrees Celsius).

2. Remove vent COVER by applying pressure at two (2) indented areas (press inward... toward center), until FLANGE is clear of BASE LIP.

3. Remove RELEASE LINER (paper cover) from adhesive section of vent (located on underside of BASE), and plase BASE onto selected mounting area. Press gently into place.

4. Cut through covering material at center of vent. Remove all covering material from vent opening.

5. Press vent firmly into place by applying pressure to both sides of Base perimiter.

6. Replace vent COVER by applying pressure at two (2) indent areas (press inward... toward center), and place both FLANGE areas UNDER Base Lips. (Note: Two (2) "Buttons" on FLANGE should be located OUTSIDE of BASE LIPS).

Back to info page