 |
"Snap" Vents
INSTRUCTION FOR "SNAP-IN" VENT
INSTALLATION SIMPLE AS A-B-C
 |
 |
 |
|
|
B. Insert "pronged" section of collar through hole in material. While holding collar inserted through hole... push the flat washer (from underside) onto the fexible progned section of collar until locked in place. All prongs (6) should be locked over flat washer for proper securement. |
C. To Atach HOOD - Push/slip HOOD under flange section of collar. Push forward until two "teeth" on back edge of HOOD lock over sharp edge. To remove HOOD, press down on front section of HOOD to lift two teeth on back edge over sharp ridge - Slide HOOD off. |
