 |
"Louver" Vent
(Model BLV-1) Self Sealing / Adhesive
INSTALLATION INSTRUCTIONS
For Plastic and/or Synthetic Material Coverings
|
****Special Note**** Selected surface area should be CLEAN, DRY and FREE OF GREASE OR OIL. Ambient/air temperature should be above 50 degrees Fahrenheit (10 degrees Celsius.) |
1
. Select an area on covering for ventilator installation.
(Note: For best result locate vent at the highest section of covering. AVOID SEAMS, FOLDS, or DEEP PERMANENT CREASES.)
 |
 |
|
2. Remove Release Liner (paper cover) from adhesive section of vent (located on underside of BASE) and place the BASE onto the selected mounting area. Press gently into place.
|
3. Cut through covering material at the center of the vent, and remove all covering material from center of vent opening. |
 |
 |
|
4. Press firmly into place by applying finger pressure to both sides of BASE perimeter.
|
5. Lock vent COVER onto BASE by pressing COVER (down) firmly onto BASE until all (3) Base-Clips are firmly attached over "flange-area" of vent cover. |
